![]() GEMINI 2 IMAGE Go to the blue panel, and select Extras / Settings, then select Kernel Modules. Ok, so now your done with the Smargo setup tools. ![]() So run the Smartreader.exe and change the kernel settings to Dreambox and click Apply. Now we need to put the smargo in the correct mode to run directly in the Dreambox. Firstly, we need to check the smargo firmware version, so run the SmartreaderUpdate.exe If the firmware is v1.3 it will say so in the status bar at the bottom of the window and you can close this util, if not, click the update button and it will apply the update. Make sure the smargo is plugged into the PC with NO viewing card in it. OK, once the drivers are installed we’re ready to go. It will prompt for drivers for the USB device, then again for the serial device.Do a manual drivers install, pointing to the Drivers_Windows folder. ![]()
0 Comments
Leave a Reply. |